[www.rhodium.ws] / [Chemistry Archive]
 

Sandmeyer Reaction of GABA to GBL/GHB

by Chromic

Quick introduction

As other writeups that I have published, this method is 100% OTC. It is awesome for a chemist who wishes to prepare GHB in small quantities and high yields and to do so without directly obtaining any regulated chemicals such as gamma-butyrolactone (GBL) or 1,4-butanediol (BDO). It also avoids the typically low yields seen from the oxidation of tetrahydrofuran (THF). It uses an easy to obtain amino acid, gamma-aminobutyric acid (GABA), and sodium nitrite (NaNO2). It scales very nicely and runs without too much hassle. Not one suspect chemical is used.

The Sandmeyer reaction uses nitrous acid to turn amines into diazonium salts. This reaction, as it applies to turning GABA into GHB, is shown in the first reaction below. Aliphatic diazonium salts rapidly undergo hydrolysis in the presence of water giving off nitrogen gas and leaving a hydroxyl group behind. This is shown in the second step. As a result of these reactions, GABA can be turned into GHB in an easy to perform one-pot reaction.

Running the reaction

Set up a 2L flask, sitting in ice-water on top of a magnetic stirrer. Now:

  1. Add 3mol GABA (309.4g)
  2. Add 3mol NaNO2 (207.0g)
  3. Add 700ml water (total volume becomes about 1100ml)
  4. Drop in a 1" stir bar and start stirring
  5. Charge a 500ml pressure equalized addition funnel with 3.3mol HCl(aq) (385.0g 31.25%, 334.8ml 31.25%)
  6. Fit the addition funnel with a gas outlet adapter and vent to theoutside

Begin slowly dripping the hydrochloric acid into the mixture. Drip it in at a constant rate of about 1 drop every 2-5 seconds. Speed it up as time progresses and replace the ice as necessary, but do not allow the evolution of the brown poisonous gas to become vigorous. After about one hour after the last drop of acid has been added, there is no need to replace the ice. Once the reaction is done, proceed to extract. (usually 24-36 hours later)

Extracting the goods

There are many options for this. This is still a work in progress, but after about 20 runs, I came to use this work up. You can use ethyl acetate (EtOAc), chloroform or methylene chloride (dichloromethane aka DCM) to perform the solvent extractions. I have normally used DCM as it's nice since the organic layer drops to the bottom of the separatory funnel.

  1. Setup for a simple distillation.
    1. Distill, throwing out the first 5-10mls, or so, of distillate as it will contain a fair amount of nitric oxides. Distill off as much water as possible, basically until the sodium chloride starts to saturate the aqueous layer and precipitate out.
    2. The remainder of the distillate (approximately 700ml) will contain approximately 1g GBL/10ml.
    3. Treat the remainder of the distillate with NaHCO3 at reflux for 30 mins
    4. Boil with about a 5% volume of activated charcoal (ie 35ml activated charcoal) (compared to the volume of the solution) for 5-10mins.
    5. Allow it to cool and filter, wash the charcoal with distilled water. Save the NaGHB.
  2. With the remainder of the aqueous, extract 5 times with 625ml portions of DCM.
  3. Distill off the DCM (reuse that DCM!).
  4. Distill the GBL (under vacuum if available).
  5. React with NaHCO3 and distilled water and treat with activated charcoal as before.

Typically 375g of NaGHB is made from the solvent extracted GBL and 100g NaGHB from the aqueous distillate. Although conversion is nearly quantitative (as measured by GC/MS), the overall recovered yield is usually about 70%.

For those who don't know how to make NaGHB from GBL using NaHCO3 please read the section on preparation of Sodium GHB using Sodium Bicarbonate (Baking Soda, NaHCO3) found in the GHB faq. Never use unknown grades of NaOH--they may contain toxic heavy metal contaminants.

OTC chemicals rock. The war is over.


Notes on procedure


References

  1. Bull. Soc. Chim. Fr.; 1; 88-94 (1989)
  2. GHB Letter to the Alabama Senate Committee on the Judiciary

Acknowledgements

Last, but surely not least, come the thank yous!

First, thank you to the girl who will always have a special place in my heart (and your determination in helping me with my struggles, especially my addiction to GHB and alcohol).

Thank you Rhodium for your hard-work and dedication to your site and the Hive in general. Thank you for pushing me to publish this document. A big round of applause for Steven Fowkes (even though you got your info wrong on MSG -> GBL in one step rxn), Fierceness, Moo, StraightEdge, hCiLdOdUeDn, Roundbottom, Osmium, Bright Star, Methyl Man, Dr_Sister, AB2, Aztec, Hypo, Ueruma, Ezekill, Terbium, Antoncho, Eleusis and Sasha Shulgin for raising my knowledge, awareness and inspiration. :)

Also thank you to the chemists who performed and published Bull. Soc. Chim. Fr.; 1989; 1; 88-94.