Author Topic: Grignard Synthesis of Chiral Amphetamines  (Read 15723 times)

0 Members and 1 Guest are viewing this topic.

Rhodium

  • Guest
Grignard Synthesis of Chiral Amphetamines
« on: May 31, 2004, 07:15:00 PM »
Asymmetric ?-Substituted Phenethylamines. V.
Synthesis of Chiral 1-Alkyl-2-phenylethylamines via Grignard Reaction of 4-Phenyl-1,3-oxazolidines

Hiroshi Takahashi,Yasuhiro Chida, Kimio Higashiyama, and Hiraku Onishi

Chem. Pharm. Bull. 33(11), 4662-4670 (1985)

(https://www.thevespiary.org/rhodium/Rhodium/pdf/meth.grignard.oxazolidine.pdf)

Abstract
Chiral N-methyl-4-phenyl-1,3-oxazolidines (2a-e) having a methyl, ethyl, benzyl, isopropyl, and cyclohexyl group at the 2-position of the 1,3-oxazolidine ring were synthesized. Reactions of 2a-e with Grignard reagents gave (1R,1'R)- and (1S,1'R)-1-alkyl- and 1-cycloalkyl-N-2'-hydroxy-1'-phenylethyl-2-phenylethylamines (3a, 3b, 3d, 3e). The absolute configurations of (1R,1'R)-3a and -3e were determined. (R)-1-Methyl- and (R)-1-cyclohexyl-2-phenylethylamines (4a, 4e) were obtained in high yield by hydrogenolysis of (1R,1'R)-3a and -3e.

All in all, this reaction may look very complicated, but it really isn't anything else than the procedure in

Post 202649

(Rhodium: "Meth via grignard rxn (Gazz Chim Italiana)", Novel Discourse)
with the difference being that the aldehyde has been made into an oxazolidine by reaction with a cheap chiral aminoalcohol. The good thing about using this oxazolidine is that 1) The yields are much higher and 2) the result isn't racemic meth, but a single enantiomer. In the article they make l-methamphetamine, but by choosing the other aminoalcohol enantiomer, the reaction will instead produce d-methamphetamine.

How do you think this reaction could be streamlined? There is really just a single obstacle in this procedure, and that is the removal of the protection group in the final step, for which they use catalytic hydrogenation. What other aminoalcohols could be used, which would be easier to remove?

Could something else be used (which would be a breeze to remove afterwards) if one would be satisfied with racemic product?



Rhodium

  • Guest
Cathinone from L-PAC
« Reply #1 on: September 27, 2004, 12:58:00 PM »
Here follows another article on the same topic as the one above (grignard addition to oxazolidines):

Untersuchungen zum Konstellationsproblem in der Ephedrinreihe
Hermann Pfanz & Gerhard Kirchner

Ann. Chem. 614, 149-158 (1958)

(https://www.thevespiary.org/rhodium/Rhodium/pdf/ephedrine.oxazolidines.pdf)

The article series below is written by the same author, and contains quite some interesting chemistry:

Imidazoline ?3 I
Gerhard Kirchner

Ann. Chem. 625, 98-103 (1959)

(https://www.thevespiary.org/rhodium/Rhodium/pdf/ephedrine.imidazoline-1.pdf)
____ ___ __ _

Imidazoline ?3 II
Gerhard Kirchner

Ann. Chem. 625, 104-107 (1959)

(https://www.thevespiary.org/rhodium/Rhodium/pdf/ephedrine.imidazoline-2.pdf)
____ ___ __ _

Imidazoline ?3 III
Über intramolekulare Oxydoreduktionen

Gerhard Kirchner

Ann. Chem. 628, 92-95 (1959)

(https://www.thevespiary.org/rhodium/Rhodium/pdf/ephedrine.imidazoline-3.pdf)

The last article contains a synthesis of cathinone from L-PAC by a simple reaction with ammonia and catalytic cyclohexanone:



?-Aminopropiophenone (Norephedrone/Cathinone)

(-)-Phenylacetylcarbinol [L-PAC] (15 g), cyclohexanone (9.8g)), and 15 mL conc. NH4OH was stirred 5 h, the mixture extracted with ether, the extract dried and distilled to give 10-11g of 3-methyl-2-phenyl-1-oxa-4-aza-spiro[4.5]decane (a.k.a (-)-4-methyl-2,2-pentamethylene-5-phenyl-?3-oxazoline, I), bp 120°C/0.3 mmHg, nD20 1.5370, [?]D20 -192.7° (96% EtOH).

I (5 g) was heated under reflux for 15 min with anhydrous IPA saturated with HCl, 0.3 ml water was added, and heating continued to give 3.7 g Cathinone·HCl, mp 182°C.


The intermediate heterocycle - 3-methyl-2-phenyl-1-oxa-4-aza-spiro[4.5]decane - can also be made from phenylpropanolamine and cyclohexanone by stirring a THF solution of the reactants over    4A Mol sieves for 24h.
Ref: Prasad, K. R. K.; Joshi, N. N.; Indian J.Chem.Sect.B 42(1),  150-153 (2003)


Rhodium

  • Guest
(-)-phenylglycinol -> d-Methamphetamine
« Reply #2 on: October 22, 2004, 04:19:00 PM »
The "one-pot" reaction of (-)-phenylglycinol with formaldehyde in the presence of KCN gave the chiral 1,3-oxazolidine (R)-1 as an oil in 94% yield. This synthon was then alkylated twice in the ?-position of the cyano group using LDA/MeI followed by LDA/PhCH2Br, the first substitution giving a product with 38% d.e.* and the second >66%.



Reduction of the crude product 3 effected decyanation and ring-opening of the oxazolidine to give 4, which in essence is an N-alkylated methamphetamine molecule. If an enantiomerically pure end product is desired, a diastereomer separation is now performed to remove the 15% or so of (R,R)-4 from the remaining 85% of (R,S)-4 through flash chromatography (silica gel, eluting with 5% MeOH in DCM). The unwanted N-alkyl group is then finally removed through overnight hydrogenolysis at atmospherical pressure (MeOH, 10% Pd/C, 12h) to give (S)-N-methyl-?-methyl-phenethylamine 5 (d-Methamphetamine) in 90% yield, with preserved chirality.

The overall yield of d-Methamphetamine from the starting R-(-)-phenylglycinol is thus ~20%.


*d.e. = Diastereomeric Excess - A measure of diastereomer ratio, defined similarly to

enantiomeric excess.

(http://www.wiu.edu/users/mftkv/Chem331/enantiomericexcess.html)


Asymmetric Synthesis IV.
Preparation of Chiral ?-Aminonitriles from a new N-Cyanomethyl-1,3-Oxazolidine Synthon

José L. Marco, Jacques Royer and Henri-Philippe Husson

Tetrahedron Letters 26(30), 3567-3570 (1985)

(https://www.thevespiary.org/rhodium/Rhodium/pdf/cyanomethyl-4-phenyl-13-oxazolidine.pdf)

Abstract: The synthesis of (-)-N-cyanomethyl-4-phenyl-1,3-oxazolidine 1 is reported. Good yields and moderate diastereomeric excesses of mono- and di-substituted ?-aminonitriles were obtained from this simple chiral template.



Preparation of (-)-N-cyanomethyl-4-phenyl-1,3-oxazolidine 1

To a stirred solution of (-)-phenylglycinol (23.62g, 0.16 mol), KCN (10.4g, 0.16 mol) in water (650 mL) at pH ~3 (citric acid) was added over 30 min at room temp a solution of formaldehyde (40%, 260 mL). The reaction mixture was stirred for ar additionnal 30 min, then basified (Na2CO3) and extracted (CH2Cl2). The combined organic fractions were washed with water, dried (Na2SO4) and concentrated to give a yellow oil which was purified by flash chromatography (SiO2, hexane-AcOEt, 80:20). 1 was obtained as a colorless oil (31.15g, 94% yield, [?]20D -173°(CHCl3, c=1.4)).

Alkylation of 1 with Methyl Iodide

To a stirred solution of LDA/HMPA (1:1, 1.1 eq. 0.48 M in THF) at -78°C, was added 1 (1 eq., 0.66M in THF) via syringe over 5 min; after 15 min 1.1 eq. of MeI was added. The reaction mixture was stirred for 1 h, quenched by NH4Cl then extracted with ether, dried and concentrated to dryness. Flash chromatography of the residual oil (SiO2, hexane-EtOAc, 85:15) separated the isomers to give 2 as the major product, yield 55% (38% d.e.)   [?]20D -282° (c=2.4, CDCl3)



Asymmetric Synthesis IX:
Preparation of Chiral ?-Substituted Phenethylamines

J.L. Marco, J. Royer & H.-P. Husson

Synth. Commun. 17(6), 669-676 (1987)

(https://www.thevespiary.org/rhodium/Rhodium/chemistry/meth.n-cyanomethyloxazolidine.html)

Abstract: (S)-N-methyl-?-methyl-phenethylamines 5a-d were obtained in 56-62% e.e. from the chiral synthon (-)-N-cyanomethyl-4-phenyl-1,3-oxazolidine-1.



Alkylation of 2 with Benzyl Bromide
To a stirred solution of LDA/HMPA (1:1; 5 mmol, prepared from 3.12 mL of BuLi 1.6 M and 0.75 mL of diisopropylamine at -10°C/-30°C under a nitrogen atmosphere) in THF (20 mL) was added 2 (0.909g, 4.5 mmol, THF, -78°C) via syringe over 5 min. After 20 min, the resultant anion solution was added benzyl bromide (2 equiv.) and the mixture was stirred at -78°C for 1 h, quenched by NH4Cl then extracted with ether dried and concentrated to dryness. Flash chromatography of the residual oil (SiO2, hexane-AcOEt, 80:20) yielded compound 3, which was used in the next step without further purification.

Reductive Decyanation/Ring-Opening of 3
NaBH4 (1.1 eq.) was added portionwise to a solution of 3 in EtOH (~0.4 M); stirring was continued at room temp overnight. The solvent was removed and the residue taken up in DCM, washed with H2O and brine, dried over Na2SO4 and evaporated to dryness. The oily residue was purified by flash-chromatography (DCM-MeOH, 95:5) to give 4. The diastereomeric excess of the RS isomer was 66% and the overall yield from 1 was 30%.

Hydrogenolysis of 4 to give (S)-5 (d-Methamphetamine)
A methanolic solution (~0.2 M) of 4 was hydrogenolysed overnight at room temp, using 1 atm. H2 in the presence of 10% Pd/C. The reaction mixture was then filtered through a celite bed and the filtrate  evaporated in vacuo to yield an oily residue which was purified by flash chromatography on silica (DCM-MeOH) to give (S)-5 (d-Methamphetamine) in 90% yield (66% e.e.).