It says extract with 3 times 75 mls Et20,
Can DCM be substituted? swim doesn't like ether.
and is the 60 mls methanol in the hydrolysis neccesary? (swim remembers discussion about that, but not the result)
from 3,4-methylenedioxyphenylacetone) This key intermediate to all of the MD-series can be made from either isosafrole, or from piperonal via 1-(3,4-methylenedioxyphenyl)-2-nitropropene. To a well stirred solution of 34 g of 30% hydrogen peroxide in 150 g 80% formic acid there was added, dropwise, a solution of 32.4 g isosafrole in 120 mL acetone at a rate that kept the reaction mixture from exceeding 40 ° C. This required a bit over 1 h, and external cooling was used as necessary. Stirring was continued for 16 h, and care was taken that the slow exothermic reaction did not cause excess heating. An external bath with running water worked well. During this time the solution progressed from an orange color to a deep red. All volatile components were removed under vacuum which yielded some 60 g of a very deep red residue. This was dissolved in 60 mL of MeOH, treated with 360 mL of 15% H2SO4, and heated for 3 h on the steam bath. After cooling, the reaction mixture was extracted with 3x75 mL Et2O, the pooled extracts washed first with H2O and then with dilute NaOH, and the solvent removed under vacuum The residue was distilled (at 2.0 mm/108-112 ° C, or at about 160 ° C at the water pump) to provide 20.6 g of 3,4-methylenedioxyphenylacetone as a pale yellow oil. The oxime (from hydroxylamine) had a mp of 85-88 ° C. The semicarbazone had a mp of 162-163 ° C.