Hi
SwiK recently dreamed that he attempted to gas some xylene which was holding around 1gm of FB pseudo.
A gasser like VE's was constructed. To a 600mL bottle, CaCl2 was added to half way. Then HCl was added, untill the waterline of the HCl was 2/3rds of the way up into the CaCl2. Swik stopped pouring the HCl, however, it continued 'rising up' into the CaCl2 untill it was all saturated. Must have been pouring WAY too fast. So to correct the situation, and additional 1" of CaCl2 was added ontop of the existing stuff. This addition of CaCl2 stayed dry, and was not saturated by the existing HCl.
Large amounts of HCl gas were being produced. Pressure would build up if a lid was screwed on the bottle. SwiK attached his custom lid to the bottle (a lid with a small 12" vinyl tube coming out of it.) Gas was STILL being produced after several minutes (cough, cough...) Swik decided to insert the hose into the xylene. The xylene had been washed with a NaOH soln, then hot and room temp water. It was dried with dried epsoms after that, and then filtered untill clear.
The bottle was producing enough gas to bubble all by itself. The xylene went very white/cloudy, but no pseudoephedrine HCl precipitated out. After gassing for a few mins, the solution was filtered (SwiK was thinking that coudiness was small pseudo particles.) The filters caught no solids, and the NP remained cloudy.
Approximately 50mLs of dH2O was added to the NP along with a few drops of HCl to titrate the pseudo. It has yet to be evapped to yield the HCl. If there is no crystals upon evaporation, ther must have been a problem with the original extraction of the FB from the GUPS. If pseudo crystals do appear after the evaporation, there must have been a problem with the gassing apparatus.
Can anybee give SwiK a few tips on gassing, and VE's gasser? Are there any obvious errors in the procedure that was used here?