Swim has done the JD routine twice. First time the dumbfuck got a ball of slightly orange jello. (QUAINT WHITE 60's) FLUSH! Second, he did very cheap 60's, things were looking good till the dipshit thought he would get cute and run the" Idea" after the JD. Just eyeballed the measurements for the "Idea" juice. He used too much iso and denat. Whoosh-- the sue flew down the funnel through the filter in to the catch. He saved the Idea jucie and evaped. Lost half of the sue somewhere, could have been the humidity. Needles appeared but so did big piles of oily flem. Flushed and viewed the situation as a learning experience.
swim had a grab bag of sinus meds left, 3 boxes of dollar type reds, 2 boxes of generic 120 and 10 boxes of the Name brand 120's. The little genius cracked the shell on the 120's and removed the red via the usual methods and just let his white powder sit in a tuppoware dish till he figured out what he was gonna do. These pills are bout 3-4 months old btw, or so he said.
Found the hive, read about the tetra trap. So this is what swim did: Swim has never boiled solvents, so he did a test run. Boiled an inch of Vm&P Naptha in his homemade beaker. (A candle jar that he melted a lip into using a propane torch. ) Swim wishes he could find a local lab supply but the nearest is three hours away, and he's leary about the internet. So the brain improvised. Things proceded well, heated the naptha, saw that he wouldn't blow himself up if he was careful. Set up outside with a wet towel and a 5 gallon bucket of h2o. He then weighed the total pill mass=50g's. Weighed out 50g's of Sodium carbonate. Mixed in blender for a little past a minute. Let settle. While the pill mass settled in the blender, he got everything ready. Poured the settled pill mass into his "beaker" and added the tce till it was a mass and mixed with a stick. He would add tce, put it on the heat and stir till he was satisfied with the consistency. Then added Vm&P straight from the can to the beaker. Bout an inch and a half's worth. Put it back on the heat and added 5 tablespoons of Distilled H2o. Let it boil slightly and backed off the heat all while gently stirring with his wood dowl rod. Heated for 6 or 7 mins. Probabally a little long as swim tells me that the bottom of the pill mass got brown. He insits he kept stirring the whole damn time. Anyhoo, took the beaker off and let the contents settle, poured off the naptha through a cotton ball into a visionware pan and observed something happening in the pan as he poured. Next time swim's gonna set up a funnel with a cotton ball and a brown coffee filter as pouring through the cotton ball was slow and tedious. Put the pan in the freezer for 2 hours, removed and pre wet a brown coffee filter with vm&P. Poured the contents of the visionware pan through the prewet filter and funnel. The Naptha had bits of stuff floating through it that swim said looked like loogies. Sqeezed the excess from the filter and set to dry. Poured the Vm&P back in the pan and swirled to get the last of the stubborn saturated sue. 30 mins later (fastest dry time swim had seen in his rather limited experience) opened the filter and smiled
So this is what it looks like!!! Sparkly fluffy shit that doesnt goop to the razor when chopped. Yield was crap, but that was just one pull. Swim saved the Vm&p and put it back in the freezer. Kept the pill mass and will do the other two pulls tomorrow.
Swim just want's it pretty clean, as he will dance with anne when the time comes.
Hope swim's experiece helped somebee. He is very excited
If any of the bee's see some errors in swim's process, or have a suggestion for improvement please contribute.