how to seperate acetiminophen from pseudo,

[SPINNERBAIT]

[12cheman12]

This isnt a charity mate. UTFSE.
Do your own research, but because ive waisted my time replying i might as well give you some help.
Acetaminophen (as it is properly spelt) is also know as paracetamol. You would of found this out if you did a simple search.
Now that you know its Para, UTFSE.

[NaXen]

hint: dont use pseudo with other actives in it

[natronFTW21]

add hot water to pill mass, then add lye until ph 12,now add np solvent,stir,pour np through filter into clean jar, dry np,filter out drying agent and gas with hcl

[navarone]

man thats the most fucked extraction someone can make.

ull have hell lots of impurities with that kind of extraction! u didnt even do the alchol extraction and the toluene extraction.

if u managed to make meth with that..then ur fucking lucky there where no chemicals that interfered the reaction......but still that extraction sucks pretty much.


to get a pure pseudo the steps are:

1 crush pills into powder.

2 soak them in ANHYDROUS alcohol for 2 minutes with stirring.

3 filter the solution and once the filtration is done wash the filter with anhydrous alcohol to cath remaining pseudo in the filter paper.

8 pour the liquid in to a large pyrex container and let it evaporate at low heat 60-70c to prevent chemicals reacting with the pseudo. use a thin layer to speed evaporation.

9 product is totally dry....crush it up again and soak it in distilled water for 2 minutes with stirring.

10 filter the liquid and again wash the filter with distilled water to catch remaining pseudo.

11 boil ur liquid under 100-110c until totally dry.

12 crush the remaining crystals into a fine powder and soak it in toluene for 5 minutes under heat (50c)

13 filter ur crystals and wash again the filter with toluene. tis time pseudo is gonna be trapped into the filter.

14 pour out the toluene and wash the receving flask of the filtration apparatus, pour water into filter with the crystals from step 13. pseudo gest down ito recever.

15 collect all the liquid and add naoh until ph 14 let it settle.

!!! most people do the np extraction to get the pseudo but it found out a way to get almost pure pseudo without using np. !!!

16 pseudo freebase is insoluble in water so filter the crystals formed in the naoh addition. once the filtration is done wash the filter many times with distilled water to remove naoh particles and to return the ph to 7......after that give it a few other washes to remove polimers.

17 trow away the mix of the recever and clean the recever carefully.

18 pour dilutet hydrochloric acid into the filter until crystals disslve completely and get into the recever. if anything stays in the filter after addig hcl..those are impurities.

19 evaporate the remaining liquid until dry. once dry pour just a little bit of distilled water and let it evaporate again to remove exess of hcl trapped into the crystals.

20 pseudo 85-95% purity baby!!!!



attempting ghetto extractions may fuck up the reaqction cuz of impurities in da meth.
guys....dont try shortcuts.whats writen on this website is the necessary to get a decent products. dont do any smart ass shortcuts cuz they fuck up frequently.

[Lestat]

The procedure for getting rid of paracetamol/ataminophen is much simpler than most, as paracetamol is scarecly soluble in very cold water, while ephedrine/pfed is very sloble, so you can use very cold ice water to dissolve the pill mass, use as small a volume of H2O as possible, and most if not all of the pfed/eph will dissolve, leaving the paracetamol to me filtered off.

Then do whatever extractions are neccesary to beat any gaaks that might bee in the pills.