Can someone give a detailed method on transfering this chemical from point A to B, point A being a large container, point B being a smaller 50ml flask w/stopper.
I attempted to do this, and it was very hard to tell how much was being poured out of bottle as a shit load of what smelled like hcl gas came out of the mother bottle, making it hard to judge amounts.
I suspect about 20ml's made it in there before I had to vacate the area due to the gas this chem released. When I put the capo back on the mother bottle it fumed for a minute or two with the cap on tight!! It was not flushed with nitrogen as none was around at the time.
Will this cause problems when I go to reopen the mother bottle? The work space had been purged of moisture with a heavy duty dehumidifier, but that didn't seem to stop the fumes from being released from the liquid. Would this stuff fume in 0% humidity?
Most importantly, and my biggest concern is the mother bottle not being purged with N2 before caping it back up for storage. Will the small amount of o2/moisture that may have been in the air and may have made it's way into the mother bottle (95% full) react with the SnCl4 being stored in it? If so, will it just react till the moisture is consumed?
Is a fume hood needed to perform small 1-10 ml SnCl4 rxn's safely? I know it's preffered, but is it necessary?
Lastly, what are those fumes? It smelled identical to hcl gas, but way more concentrated. I may have inhaled a small amount, but im alive and typing!
First time SnCl4 user,
Midi