The Vespiary
The Hive => Stimulants => Topic started by: losthope on August 04, 2004, 10:55:00 PM
-
-
Is methane not a gas?? Did you mean Meth ?
be more specific, what methods did you use, so on. Maybe then you might get help.
-
take your oil,check ph,take one cup warm water,one spoon red devil lye,mix,and pour 1/2 the cup thru your oil,let settle and room temp,check ph again.you want 12 to 14 ph level;before gassing,which will be cut in 1/2 for product when u gas.,,,Before ph-ing...run an aquarium pump (airiate)your oil for a couple hours to get rid of gas. Use salt and sulphuric, instead of A&M or A&H...better gas better control.On an R$B.,,the PH must be right to GAS ,unlike shaker way...Humidity will kill any gas return also. 70 degrees with no more than 60% humidity., is ideal.[purple]
-
You should stir the meth oil in a suitable nonpolar solvent before gassing.
-
How much NP is the right ratio to dissolve the FB before gassing ( ex. 20ml FB in ????ml Toluene) ?
After steam distilling of the FB, is then a (5%) NaOH wash recommendable (before H20 and brine) or is this overkill/nonsense?
only water/brine washes are enough?
thx