endo1: That site looks like it just may have the info SWIM needs. Thanks for the link! SWIM has merely enough time to reply and not enough to work on/figure this thing out. SWIM plans on using 120V and has no idea what voltage it previously operated at.
8ball: SWIM apologizes for the diagram once again as it was done in a horrible rush. The wires were numbered (if poorly). Wires 1,2,3, and 5 are white, white, black, and white, respectively. These are the ones that SWIM doesnt know where to put. SWIM does suspect two are for the light sensor which he would very much like to bypass anyhow. And SWIM does not understand what you mean about the ballast being disconnected. IF you are referring to the diagram then you must know that everything is indeed inside the outer casing drawn and was simply drawn outside b/c SWIM suspected one electronically inclined could figure out the proper voltage to use by reading the lines on the resistor and the capacitor codes and such on the transformer. Also, SWIM's jaw dropped when you told a tale of priceless HPS power! and would very much like to know more when the time is right!