how does 12.5 g. FB return from 6/20 ct generic 120's sound ?
also tested on 60's with chlor and or trip, as well as highly gakked red hots.
follow directions closely because too much NH3 will fuck it up, causing a large yeild loss
This is a variation on the Tetra Trap method and has also been very successful using only sodium carbonate without TCE,although this required adding a small amount of NH3 when the pillmass started to clump while heating,only add enough to make it pasty again
a spray bottle on mist setting works best the pills can be combined with same results#1
combine all the pills with an equal amount of sodium carbonate and grind to a fine powder in a heavy duty coffee grinder or blender. let it sit for 5 minutes#2
place pillmass in visionware/corningware casserole dish,spray a small amount of TCE into it, enough to slightly wetten the pillmass,it should still be dry and clumpy at this point#3
cover pillmass with a minimum of 1" Xylene/Toulene(dont use naptha or the return will not be as high) now add NH3 while gently heating, A spray bottle on mist setting works very well.Stir contiunously while adding NH3 until the pill mass becomes a fluid paste,Keep stirring and increase heat until a gentle boil starts, this allows the NH3 to evaporate, SWIM uses a respirator while doing this, suggest you do too.while still hot filter the NP through 1 coffee filter.Immediately add more NP to cover pilmass to a minimum of 1/3 inch. More than that is ok but evaporating solvents is a nasty task.quickly bring this up to a boil and filter through same coffee filter#4
evaporate the NP in front of a box fan or however you prefer to do it,heating the NP solution to about 95 deg one time before evapping it speeds up process#4
come back later to find a solid carpet of good size FB crystals,Short Path Distillation of the FB will eliminate any gakk as long as you dont rush things and overheat the pillmass![](https://www.thevespiary.org/rhodium/Rhodium/hive/hiveboard/picproxie_docs/000535119-setup02.jpg)
be sure to evap all the solvent from the FB before starting SPD,failure to do so will prevent the snowstorm effect making it more difficult to fine tune temp. as well as causing the FB to stick to the sides of the horizontal pipe and flask making it more difficult to get the FB out when finished, a small aquarium pump as a air supply will work, but a vacuum source is better becauese theres fewer clogs of the pipe and better control of the flow.
#5[/red]bring up temperature slowly untill you see what looks like snowflakes falling out in flsk, when this hapens start up airflow untill you see q flow of glittery xtals moving down pipe and slowly falling out to bottom of tube. If you get this right most of the FB will be in the tube dry and ready to react, this eliminates a final solvent evaporation and is the exact temperature desired.
Any suggestions to the design are welcome.
Enjoy some real fine FB to react ghetto as hell and also the most effective methos SWIM has found, unlike KOH all the pills can be processed together brand name, other actives have not had any effects so far, even used the blue tabs with diphenhydramine, although that required the filtering of the large gakk free FB crystals from the xylene while evapping at room temp, these crash out before the fine sugary diphenhydramine xtals did. By the way these were found to be gakk free with burn test without need of spd! cleanest burning pfed SWIM has seen this year, turned clear as water and just vanished,
SWIM encourages more rersearch using pills with other actives, as this has worked on every brand and type tested so far