.2ampsat24 v is an unusually low current for that V:
?? get another pot:
10 V should give you 2X that much: although without knowing your set up, this is specious reasoning...
The worlds easiest set up is a standard pot inserted into the BOTTOM of a cut-off 2 liter soft drink bottle.
The cathode is in the bottom, symettrically placed, the teflon wrapped current supply wire passes through a sealed hole..
There IS a standard pot which will JUST FIT, and the tera cotta RIM rests on the rim of the cut off bottle...
Note that this seals the catholyte from air, enhancing appropriate reactivity therein
Now you take another 2 liter soft drink bottle, cut it off at the appropriate height to accomplish the following:
1. melt a hole in the screw cap 3/8 diameter to pass the carbon electrode anode which you got from a welding supply shop for $.50
2. A standard condom will be passed thru the screw on opening from the bottom, maybe 1/2 inches worth, and the screw on cap will be screwed on tightly enuff to hold it in place, and not so tight as to rip it. They ARE tough..
3. the top section will be placed INSIDE the tera cotta pot:
this will necessitate 3 verticl slits symettrically place so the "legs" thus form can overlap to accomodate the reduced diameter of the pot inside...
4. The height will be adjusted so that the condom reaches down to about an inch from the pot bottom.
5. Your 10 to 15% HCl will be added to the pot, and to the condom through the anode hole, keeping the levels about thesame.
6. You will insert the anode, NOT allowing contact with the skin.
This dual membrane system will have significantly less R than your set up: probably because of the large submerged pot surface area.
It was found to be as effective as a pressurized systemI built in reductive process. And takes about maybe an hour to build...
I'll take some pictures...
dwarfinger:
He's the dwarf wit' der GOLdenNose <hmm>