Ok, after tons of searching and reading and searching...I am finally going to post a question here. Please be gentle
.
I'm not kidding, I've been lurking around here for over a year. I've done a couple of very, very small NANOs. So, finally got the nerve up to go a little bigger (not much, but still). Anyway, on to my question.
SWIM was going to try the P/P. Got everything together. Cleaned and cleaned the E, mbrp, and i2. Turned out had way too much E for the amount of rp, so batch was going to be smaller than hoped for. Started out with 6e/7i/3.5rp. Everything went as expected. Reaction looked like what SWIM had read about...smoke and all. pH looked good...everything.
End product smoked clean with no residue...VERY effective (Swim's been up almost 24hrs
). Problem is, only came out with 1g go-go. Seems like there should've been more...right?
If so, what was done wrong? Everything was saved...is it possible to 'push' more out?
Don't get me wrong--this bee is EXZTREMELY estatic that there WAS and end product. She was just hoping for a little more..