Author Topic: MDA the easy way  (Read 5710 times)

0 Members and 1 Guest are viewing this topic.

foxy2

  • Guest
MDA the easy way
« on: June 11, 2000, 10:13:00 AM »
How does this sound? A friend of mine has access to some stuff and he was wondering if it would work.  He knows the yeild will not be stellar but thats ok.

Ok lets say
STEP#1
Safrole + KI + H3PO4 --> 2-iodo-safr(whatever)
you know what i mean
He assumes this step will give reasonable yeilds?

STEP#2
Add DCM and H2O, save DCM layer.  Then wash H2O with more DCM and save. Repeat.

STEP#4
Pull off/evaporate DCM under vacuume.

STEP#5
Iodo-Safr + NH3(anhdrous) -->  MDA + Junk

STEP#6
Distill off MDA fraction under vacuume

Step#7
Acid/Base extract to remove any leftover iodo-safr

Step#8
Dry final extract for pure MDA crystal


Any feedback would be much appreciated ;)






slappy

  • Guest
Re: MDA the easy way
« Reply #1 on: June 12, 2000, 02:20:00 AM »
No, it own't work. This subject has been thoroughly discussed over the years.


foxy2

  • Guest
Re: MDA the easy way
« Reply #2 on: June 12, 2000, 04:56:00 AM »
Well have you seen the MMDA synthesis suggested on Rhodiums site?  This seems to indicate that such a scheme may work.
This very method is described when starting from Myristicin.  I would assume that Rhodium wouldn't put up to much bullshit.


foxy2

  • Guest
Re: MDA the easy way
« Reply #3 on: June 12, 2000, 04:57:00 AM »
Oh yea. Which step will not work?  If i must refine it where should i look?


CHEM_GUY

  • Guest
Re: MDA the easy way
« Reply #4 on: June 13, 2000, 12:25:00 AM »
I don't know about the use of H3PO4 and KI, but I know that 48% HBr will work. 

This post is for informational purposes only an is not intended to facilitate illegal activity.

element109

  • Guest
Re: MDA the easy way
« Reply #5 on: June 13, 2000, 06:25:00 PM »
You won't get HI from KI+H3PO4 without heat (60-80C), and channeling the gas through saf BUT SWIM tried once and ditched the shit because it has an evil suckback and was in one word messy. This is a good way to make aqeuous HI , but there are better ways to make anhydrous HI gas.


E109-

mrvegas

  • Guest
Re: MDA the easy way
« Reply #6 on: June 14, 2000, 12:43:00 AM »
Try looking into bromination with HBr, anhydrous HBr(g) is used in metal etching

The Force is like duct tape, it has a light side and a dark side and it holds the universe together