get a 12oz long neck beer bottle,6" piece of 1/2"ID braded pvc hose,4'section of 1/2" OD pvc pipe,end cap for pvc pipe ,3 pieces of clear plastic water line about 10' long,3/8,5/16"&1/4",easily found at you friendly neighborhood apliance store,a couple of cheep sponge paint brushes.OK ,first thing to do is drill a 7/16" hole in the pvc end cap,set aside for later,cut your 1/4 " & 5/16""water line in half,set aside, take your piece of 1/2"Braded hose & slide it half way on one end of your 4' pvc pipe,secure with black tape,put a gennerous amount,there is alot of heet & pressure,you don't want any leaks or melt downs,cap off the other end.cut a couple 1"x1/4" pieces of sponge from piant brush ,stuff it in each end of 1/4" line,make sure it's snug ,dont over pack it & cause a blockage, force the 1/4" line through the hole in end cap 5" deep,aply black tape so it secures the end cap & seals the gas line,insert a 5/16" piece of gas line into the 1/4"gas line,pushing the foam filter in about 1".do the same with the 10' piece of 3/8" gas line..coil up your hose & secure with tape,leaving enough to work with....Get a helper to add the juice ..drop the bomb & slide the rubber hose end over the beer bottle,holding the pvc pipe upright & aplying downword pressure keeping a good seal...