Author Topic: H3PO3 reactions quesions and clarifications.  (Read 2457 times)

0 Members and 1 Guest are viewing this topic.

ITP

  • Guest
H3PO3 reactions quesions and clarifications.
« on: March 16, 2004, 09:51:00 PM »

SHORTY

  • Guest
A few points??????????????????
« Reply #1 on: March 17, 2004, 04:30:00 AM »
Yes 500ml too big, yes 250ml is ok for 10g
Yes a condenser is needed
Any thick balloon is fine if placed on the condenser

Use a condenser to avoid odor and prevent loss of HI.
Goggles won't do much for your lungs.
Oil bath is fine.
Cold wet towels on neck not necessary and possibly dangerous
Don't know what you mean by first rxn

For the rest of your questions please use tfse.


ITP

  • Guest
Wait a sec, SWIM was using your advice on not...
« Reply #2 on: March 17, 2004, 12:02:00 PM »
Wait a sec, SWIM was using your advice on not using a condenser.  You said to right here

Post 428219 (missing)

(SHORTY: "Good Job", Stimulants)

And in regards to the first/second reactions

The first is when the HI is created, where no pseudo is present.   The second reaction is when the pseudo is present and the actual meth is created.

And I was asking is a Osha gas mask needed when you might have contact with HI?

Scottydog

  • Guest
818 hits in the search engine
« Reply #3 on: March 17, 2004, 05:59:00 PM »
Swim just used the search engine and got 818 hits. In those posts you will pretty much find everything you need to know.

The hive is like an encyclopedia of theoretical drug synths and related information. Its much easier then an encyclopedia because all you have to do is push a few buttons.  ::)

Here is a good place to start:

Post 424390 (missing)

(apprentice: "phosphorous acid", Stimulants)


If you have any further questions after reading the above thread.

You can familiarize yourself with the hive search function:


https://www.the-hive.ws/forum/search.pl?Cat

=


SHORTY

  • Guest
Yes but you seem to bee so concerned
« Reply #4 on: March 17, 2004, 08:23:00 PM »
About odors and losing HI so therefore a condenser would bee a good idea.  Plus, i have never done a phosphorous acid synth and most who have use a condenser or at least some type of tubing etc..