Okay so if someone were to currently be using a ball mill combined with a V type mixer and a 4T press with a number of differnt die sets ect. What would be the propewr method to go about production of a tablet containing 5meo-dipt.
The problem that is faced is the smal amount or active ingredient vs. the total size of the tablet. I can go down to 5mm, and use binders, ect for the rest, but I am concearned about proper mixing of a 10mg dosage unit is a 100mg tablet, the margin for mis mixing is too large for saftey and also for quality control of the product, too much or too little.
Fluid bed granulation seems to be an attractive method for mixing and dispersal of the tryptamine, but then again fluid bed granulation machines are a little out of the old price range for an experiment at $15,000, if I knew for a fact I could hold a +/-1mg tolerance with that sort of mixing I would go for it, but. . .
A large scale production of 5meo-Dipt seems to be in order, however this problem evades me.
I have also considered using many very small gel capsules, but then again the price for a filling machine is close to $15,000, seems a bit wasteful with a lab full of tableting equipment. With a production goal of 100,000 tablets hand measuring is out of the question.
Ideas would be helpful, perhaps if we can get the method down for 5meo-dipt 5meo-amt at a 3-5mg dosage could also be accomplished, or any of the other low dosage types of tryptamines.
Cyril
So you need a precursor to a pecursor, just to make a precursor